TinkerKit 2/3 Axis Accelerometer module T000020

Osnovne značajke
  • Šifra proizvoda: 8206000020
112,00 kn u dućanu
108,64 kn
Isporučivo: 1 dan
Jednokratno plaćanje:
Internet bankarstvo (virman)
American Express, MasterCard, VISA, Maestro
Obročno plaćanje:
American Express 2-10 rata
DOSTUPNOST PO POSLOVNICAMA:
ZAGREB - VUKOVARSKA, SPLIT, WEB SHOP
  • Arduino

    Arduino je talijanska kompanija specijalizirana za elektroniku. Osnovana je 2005. godine u Italiji. Arduino je softverska i hardverska kompanija koja je posvećena kit elektronici. Također nudi i vlastiti programski jezik i veliku bazu znanja i uputa za izgradnju elektroničkih sustava. Chipoteka vam nudi veliki izbor kit elektronike marke Arduino koja je idealna za hobiste i učenje elektronike i elektroničkih programa.

  • OPIS

    The T000020 TinkerKit is based on the LIS344AL, a three axis accelerometer.
    You can get data about the third axis (referred to as Z) by soldering a header to the through hole labelled Z.
    On the back of the module you can find two signal amplifier and a green LED that signals that the module is correctly powered.
    This module outputs 0V to 5V on one of its two signal pins when its G force is changed (e.g. is moved).
    The value is approximately 2.5V when there is 0G on the X or Y axis.
    When you connect this module to the input on an Arduino using the TinkerKit shield, you can expect to read
    values between 0 to 1023 while moving the module.

    This module is a sensor.
    The connector is an output which must be connected to one of the input connectors on the TinkerKit shield.

    ±3.5g full scale
    Output voltage, offset and sensitivity are radiometric to the supply voltage
    Factory trimmed device sensitivity and offset