Motor micro 6 Vdc sa reduktorom 100:1, Pololu 992

Osnovne značajke
  • Šifra proizvoda: 8090008001
240,00 kn u dućanu
228,00 kn
Isporučivo: 1 dan
Jednokratno plaćanje:
Internet bankarstvo (virman)
American Express, MasterCard, VISA, Maestro
Obročno plaćanje:
American Express 2-10 rata
DOSTUPNOST PO POSLOVNICAMA:
ZAGREB - VUKOVARSKA, SPLIT, RIJEKA, OSIJEK, ZAGREB - ARENA, ZADAR, ŠIBENIK, PULA, WEB SHOP
  • OPIS

    This gearmotor is a miniature high-power brushed DC motor with long-life carbon brushes and a 100.37:1 metal gearbox.
    It has a cross section of 10 × 12 mm, and the D-shaped gearbox output shaft is 9 mm long and 3 mm in diameter.

    Key specs at 6 V: 320 RPM and 120 mA with no load, 30 oz-in (2.2 kg-cm) and 1.6 A at stall.


    These tiny brushed DC gearmotors are intended for use at 6 V, though in general, these kinds of motors can run at voltages
    above and below this nominal voltage, so they should comfortably operate in the 3 – 9 V range (rotation can start at voltages as low as 0.5 V).
    Lower voltages might not be practical, and higher voltages could start negatively affecting the life of the motor.
    The micro metal gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and with four different motors:
    high-power with long-life carbon brushes (HPCB), high-power with shorter-life precious metal brushes (HP), medium-power (MP), and low-power.