Sredstvo za kositrenje tiskanih pločica, 90 g
- Šifra proizvoda: 2630701260
Internet bankarstvo (virman)
American Express, MasterCard, VISA, Maestro
American Express 2-10 rata
ZAGREB - VUKOVARSKA, SPLIT, RIJEKA, OSIJEK, ZAGREB - ARENA, ZADAR, ŠIBENIK, PULA, WEB SHOP
A high-quality currentless (chemical) bath for printed circuits.
It creates hermetic,glossy, 5-12 µm thick coatings with very good adhesion.
The preparation provides protection against harmful effect of air and moisture.
Type of chemical agent tinning agent
Package type plastic container
Application for PCBs chemical (non-current) tinning
1.Package contents dissolve in 1.0 l of water at a temperature 80-90 °C
( recommended to use of distilled or demineralized water ).
2. Stir until fully dissolved solution, allow to cool to temperature room.
3. Clean your board carefully.
4. Tin by immersion in compiling at temperature 20-30°C for 5 minutes to few
hours depending on the desired film thickness ( max 12 µm).
5. Thoroughly rinse the board ( first in cold then in hot water ) and dry.