Silikonska pasta 2,7g Arctic Silver Céramique 2
- Šifra proizvoda: 8073440115
Internet bankarstvo (virman)
American Express, MasterCard, VISA, Maestro
American Express 2-10 rata
ZAGREB - VUKOVARSKA, SPLIT, RIJEKA, OSIJEK, ZAGREB - ARENA, ZADAR, ŠIBENIK, PULA, WEB SHOP
Like the original Ceramique, Ceramique 2 uses only ceramic fillers so it is neither electrically conductive nor capacitive.
The tri-linear composite of aluminium oxide, zinc oxide and boron nitride allows the thinnest possible bond line with modern processors,
heatsinks and electronics. Critically-sized particles and new ultra-high shear mixing techniques maximize
Ceramique 2's thermal performance and help maintain a stable homogeneous suspension.
This exclusive combination provides performance exceeding most metal based compounds.
Polysynthetic Suspension Fluid
A new oil mixture, improved thermal filler properties and increased particle deagglomeration,
dispersal and density enhance Ceramique 2's thermal performance and overall stability.
The third generation polysynthetic suspension fluid combines advanced synthetic oils to maximize
wetting and stability while allowing a higher density of thermally conductive fillers.
Ceramique 2 is engineered to not separate, run, migrate, or bleed.
Ceramique 2 does not contain any metal or other electrically conductive materials.
It is a pure electrical insulator, neither electrically conductive nor capacitive.
2 to 10 degrees centigrade lower CPU full load core temperatures than standard thermal compounds or thermal pads
when measured with a calibrated thermal diode embedded in the CPU core.
The amount of compound remaining in the 2.7-gram syringe is easy to determine as the rear of the plunger is perfectly
flush with the flange when the syringe is empty.
Easy Clean Up
Ceramique 2 can easily be cleaned from CPUs and heatsinks with ArctiClean, isopropyl alcohol or any of the cleaners listed in the product instructions.
Due to the unique shapes and sizes of the particles in Céramique 2, it will take a minimum of 25 hours and several thermal cycles
to achieve maximum particle to particle thermal conduction and for the heatsink to CPU interface to reach maximum conductivity.
(This period will be longer in a system without a fan on the heatsink.)
On systems measuring actual internal core temperatures via the CPU's internal diode, the measured temperature
will often drop slightly over this "break-in" period.
This break-in will occur during the normal use of the computer as long as the computer is turned off from time to time and the
interface is allowed to cool to room temperature. Once the break-in is complete, the computer can be left on if desired.