Arduino Ethernet Rev3 WITH PoE A000074

Osnovne značajke
  • Šifra proizvoda: 8201000074
618,00 kn u dućanu
599,46 kn
Jamstvo: 12 mjeseci Isporučivo: 1 dan
Jednokratno plaćanje:
Internet bankarstvo (virman)
American Express, MasterCard, VISA, Maestro
Obročno plaćanje:
American Express 2-10 rata
DOSTUPNOST PO POSLOVNICAMA:
ZAGREB - VUKOVARSKA, SPLIT, RIJEKA, OSIJEK, ZAGREB - ARENA, ZADAR, ŠIBENIK, PULA, WEB SHOP
  • Arduino

    Arduino je talijanska kompanija specijalizirana za elektroniku. Osnovana je 2005. godine u Italiji. Arduino je softverska i hardverska kompanija koja je posvećena kit elektronici. Također nudi i vlastiti programski jezik i veliku bazu znanja i uputa za izgradnju elektroničkih sustava. Chipoteka vam nudi veliki izbor kit elektronike marke Arduino koja je idealna za hobiste i učenje elektronike i elektroničkih programa.

  • OPIS

    The Arduino Ethernet is a microcontroller board based on the Arduino Uno, and incorporating a
    WizNet W5100 TCP/IP Embedded Ethernet Controller. It can be programmed like an Uno via a sixpin FTDI
    style serial connector. The Arduino USB 2 Serialadapter or any FTDI style USB to serial connector can be used to program it.
    Additional features coming with the R3 version are:
    ?
    1.0 pinout: added SDA and SCL pins for TWI communication placed near to the AREF pin
    and two other new pins placed near to the RESET pin, the IOREF that allow the shields to
    adapt to the voltage provided from the board and the second one is a not connected pin,
    that is reserved for future purposes.
    ?
    stronger RESET circuit.
    A separate power-over-Ethernet (PoE) module is soldered to the board to provide power from a
    conventional twisted pair Category 5 Ethernet cable. It is IEEE802.3af compliant, and works with
    all compliant PoE injectors currently available.

    Technical Specifications
    Microcontroller ATmega328
    Operating Voltage 5V
    Input Voltage (recommended) 7-12V
    Input Voltage (limits) 6-20V
    Digital I/O Pins
    14 (of which 4 provide PWM output)
    ?
    Arduino Pins reserved
    o 10 to 13 used for SPI
    o 4 used for SD card
    o 2 W5100 interrupt (when bridged)

    Analog Input Pins 6
    DC Current per I/O Pin 40 mA
    DC Current for 3.3V Pin 50 mA
    Flash Memory
    32 KB (ATmega328) of which 0.5 KB used by bootloader
    SRAM
    2 KB (ATmega328)
    EEPROM
    1 KB (ATmega328)
    Clock Speed
    16 MHz
    W5100 TCP/IP Embedded Ethernet Controller
    Power Over Ethernet ready Magnetic Jack
    Micro SD card, with active voltage translators